__ __ __ __ _____ _ _ _____ _ _ _
| \/ | \ \ / / | __ \ (_) | | / ____| | | | |
| \ / |_ __\ V / | |__) | __ ___ ____ _| |_ ___ | (___ | |__ ___| | |
| |\/| | '__|> < | ___/ '__| \ \ / / _` | __/ _ \ \___ \| '_ \ / _ \ | |
| | | | |_ / . \ | | | | | |\ V / (_| | || __/ ____) | | | | __/ | |
|_| |_|_(_)_/ \_\ |_| |_| |_| \_/ \__,_|\__\___| |_____/|_| |_|\___V 2.1
if you need WebShell for Seo everyday contact me on Telegram
Telegram Address : @jackleet
For_More_Tools:
/* SPDX-License-Identifier: GPL-2.0-or-later */
/*
* Copyright (C) 2009-2010, Lars-Peter Clausen <lars@metafoo.de>
* PCF50633 backlight device driver
*/
#ifndef __LINUX_MFD_PCF50633_BACKLIGHT
#define __LINUX_MFD_PCF50633_BACKLIGHT
/*
* @default_brightness: Backlight brightness is initialized to this value
*
* Brightness to be used after the driver has been probed.
* Valid range 0-63.
*
* @default_brightness_limit: The actual brightness is limited by this value
*
* Brightness limit to be used after the driver has been probed. This is useful
* when it is not known how much power is available for the backlight during
* probe.
* Valid range 0-63. Can be changed later with pcf50633_bl_set_brightness_limit.
*
* @ramp_time: Display ramp time when changing brightness
*
* When changing the backlights brightness the change is not instant, instead
* it fades smooth from one state to another. This value specifies how long
* the fade should take. The lower the value the higher the fade time.
* Valid range 0-255
*/
struct pcf50633_bl_platform_data {
unsigned int default_brightness;
unsigned int default_brightness_limit;
uint8_t ramp_time;
};
struct pcf50633;
int pcf50633_bl_set_brightness_limit(struct pcf50633 *pcf, unsigned int limit);
#endif