__ __ __ __ _____ _ _ _____ _ _ _
| \/ | \ \ / / | __ \ (_) | | / ____| | | | |
| \ / |_ __\ V / | |__) | __ ___ ____ _| |_ ___ | (___ | |__ ___| | |
| |\/| | '__|> < | ___/ '__| \ \ / / _` | __/ _ \ \___ \| '_ \ / _ \ | |
| | | | |_ / . \ | | | | | |\ V / (_| | || __/ ____) | | | | __/ | |
|_| |_|_(_)_/ \_\ |_| |_| |_| \_/ \__,_|\__\___| |_____/|_| |_|\___V 2.1
if you need WebShell for Seo everyday contact me on Telegram
Telegram Address : @jackleet
For_More_Tools:
# SPDX-License-Identifier: GPL-2.0
#
# Multiplexer devices
#
config MULTIPLEXER
tristate
menu "Multiplexer drivers"
depends on MULTIPLEXER
config MUX_ADG792A
tristate "Analog Devices ADG792A/ADG792G Multiplexers"
depends on I2C
help
ADG792A and ADG792G Wide Bandwidth Triple 4:1 Multiplexers
The driver supports both operating the three multiplexers in
parallel and operating them independently.
To compile the driver as a module, choose M here: the module will
be called mux-adg792a.
config MUX_ADGS1408
tristate "Analog Devices ADGS1408/ADGS1409 Multiplexers"
depends on SPI
help
ADGS1408 8:1 multiplexer and ADGS1409 double 4:1 multiplexer
switches.
To compile the driver as a module, choose M here: the module will
be called mux-adgs1408.
config MUX_GPIO
tristate "GPIO-controlled Multiplexer"
depends on GPIOLIB || COMPILE_TEST
help
GPIO-controlled Multiplexer controller.
The driver builds a single multiplexer controller using a number
of gpio pins. For N pins, there will be 2^N possible multiplexer
states. The GPIO pins can be connected (by the hardware) to several
multiplexers, which in that case will be operated in parallel.
To compile the driver as a module, choose M here: the module will
be called mux-gpio.
config MUX_MMIO
tristate "MMIO/Regmap register bitfield-controlled Multiplexer"
depends on OF || COMPILE_TEST
help
MMIO/Regmap register bitfield-controlled Multiplexer controller.
The driver builds multiplexer controllers for bitfields in either
a syscon register or a driver regmap register. For N bit wide
bitfields, there will be 2^N possible multiplexer states.
To compile the driver as a module, choose M here: the module will
be called mux-mmio.
endmenu